Author Topic: Packer Placement? (Read 2120 times)

C-Jay · « **on:** February 27, 2006, 10:10:15 AM »

I have managed to pull off a few cool jumps with via Packer and I was wondering how do you guys know how to place the Packer just right so your NRG will hit the ledge or side

I place it randomly but only a few tries out of 5 million will get right

Whats your secret

Xtramus · « **Reply #1 on:** February 27, 2006, 10:11:17 AM »

Adjust every now and then, push it away a little and stuff. That usually makes it a bit easier. But still, it'll take a lot of tries.

ImPaKt · « **Reply #2 on:** February 27, 2006, 10:21:13 AM »

just place it so it points up just below the edge, then if it's not getting u much height, nudge it forward a tiny way, or vice versa push it back if it's too close or ur bailing.

I'm a little stuck coz the one i wanna do, i need more height bu can't put it forward. I'm inches out.

Xtramus · « **Reply #3 on:** February 27, 2006, 10:23:50 AM »

Shoot the front or rear tires then, that makes it go higher/slower, shoot the rear ones for more height from the packer and shoot the front to make it a bit lower. Or shoot both for a tiny all around lower.

InsaNe · « **Reply #4 on:** February 27, 2006, 10:38:15 AM »

In SA its not matter how your packer is, or am i just so skilled that i success nearly every bump

NightFear · « **Reply #5 on:** February 27, 2006, 01:56:51 PM »

It's not magic, just try it until you've done it

Kert · « **Reply #6 on:** February 27, 2006, 02:08:10 PM »

Quote

Shoot the front or rear tires then, that makes it go higher/slower, shoot the rear ones for more height from the packer and shoot the front to make it a bit lower. Or shoot both for a tiny all around lower.

My tip

Well, you cant do good bumps with every setup (@ insane) you still need to find that perfect spot...

Juan · « **Reply #7 on:** February 27, 2006, 04:35:46 PM »

have the camera behind the packer then with the right analog stick move it down until the camera is near the ground behind the packer, you should be able to see where your going to bump. Also just adjust according to how far and how high you bump.
For example if your going for a high roof and you get alot of distance but not much height then move the packer a little closer to the bump. It comes naturally after a while.

RAD · « **Reply #8 on:** February 27, 2006, 05:53:01 PM »

Pretty much what juan said is the best way to go. But remember, the closer to the bump the packer is, the earlier you have to lean back.

I've also made a couple of packer to bumps with replays and pictures to help you out, a picture being worth a thousand words and all...

Los santos sewers - 73ft

Side view

Rear view from behind the packer

Los santos crane - 93ft

Side view

Rear view

See attatchment for a couple of replays

Fate · « **Reply #9 on:** April 19, 2006, 07:58:20 PM »

Nice, RAD.

Brandon · « **Reply #10 on:** April 19, 2006, 08:21:33 PM »

what about walls shorter than those, rad?